The MaxiPoint Version 2 System
System Balancing
Resources



The MaxiPoint Version 2 System


All the features of the UniPoint RF plus:

  • From 1 to 4 hard wired wall controllers strategically placed through the house. (No more having to go downstairs in the middle of the night to turn off the system with a controller in the master bedroom AND the kitchen)
  • Up to 8 zones with the ability (via an expansion module) to go to 16 zones (for large or two story buildings)
  • The ability to group zones together for convenient usage (if you have a big family room with, maybe, three outlets, they can be programmed to open to different levels to give varied flow around the space BUT still all open or close at the same time (programming zones into a group gives you better control and more convenient operating)
  • A programmed service reminder. Your installer can programme in a forward service reminder for up to 180 days away so you are reminded to get your filters cleaned, routine maintenance BEFORE the system gets choked with everyday dirt and starts using more power/working less efficiently.

NOTE: Air Conditioning Systems are not ‘set and forget’ systems, they require similar regular servicing to a car or any other large machinery to continue operating at peak efficiency.




System Balancing
- The most difficult part of installing a Ducted A/C System

The Installer may spend hours climbing in and out of the roof to adjust airflow to each room to make sure all rooms get adequate flow. Unfortunately, in many cases this may be difficult to achieve in the allotted time.

Example: Often the room that is at the end of the longest duct run gets little or no air because of improper balancing. UniPoint RF & MaxiPoint V2 solves the difficult job of zone/system balancing.

With the unique Zone balancing ability of UniPoint RF and MaxiPoint V2 this difficult task becomes
simple and easy, guaranteeing a good result every time. The installer uses the wall mounted (MaxiPoint), or the handheld (UniPoint RF) controller to adjust the dampers in the roof WHILE HE’S IN THE ROOM checking the airflow. No more climbing in and out of the roof. He just stands in the room to check airflow is satisfactory as he adjusts all the dampers from the control. Fast and easy for him, a far better result for the client.

Note: The volume of available air is dependant on the size of the Air Conditioning Unit and also on satisfactory ducting design.




Resources

To download PDF files, right-click the link below and select 'Save Target As'


Zonemaster MaxiPoint V2 - Operation Manual (PDF 1.3MB)
Zonemaster MaxiPoint V2 - Installation Manual (PDF 3.7MB)


© Copyright 2010 Polyaire™ Pty Ltd. All rights reserved